mrfabulous963

This was discovered a few nights ago at a Basketball game by Stagg's Pep Band.


How To Make A Spitball Launcher

1) Remove Your Tuning Slide and Mouthpiece

2) Take a Paperball, about the 3/4 of the size of your leadpipe, and wet it

3) place the paperball at the end of your leadpipe(where it meets the tuning slide)

4) Blow at that same spot while aming at a target!

This Has Not Been Used on a RL horn

I AM NOT RESPONSIBLE FOR ANY PROBLEMS THAT OCCUR FROM DOING THIS
(None have happened yet)

trumpet blower88

I remember back in elementry school I actualy had these litle things called "spitballs". They were little yellow sponge thingies that had some kind of soap on it to clean the inside of your trumpet. You stick it in your lead pipe, then blow as hard as you can and it's supposed to blow though the whole horn and fly out the bell... but it would always get stuck in the valves...

__________________
-David Jacques

ScreaminRaider

That's because you didn't put your Valves down.....Try it again and put all three Valves down.

__________________
Jonathan Wright